Installation Guide
Installation Guide
- Clean the surface of your jetski where you will be applying the graphics kit. Ensure that the surface is free of dirt, grease, and any other debris that could affect the adhesion of the graphics kit.
- Unroll the graphics kit and identify the pieces that you need to install. Be sure to match each piece to the corresponding section of your jetski.
- Apply a small amount of soapy water to the surface of your jetski where you will be applying the graphics kit. This will help you to position the graphics kit correctly and prevent it from sticking prematurely.
- Apply the graphics kit to the surface of your jetski, starting at one end and working your way to the other end. Be sure to smooth out any wrinkles or bubbles as you go.
- If you need to reposition the graphics kit, carefully peel it off the surface and reapply it.
- Once the graphics kit is in place, use a squeegee or similar tool to smooth out any remaining bubbles or wrinkles.
- Finally, use a spray bottle filled with water to wet the surface of the graphics kit. This will help to activate the adhesive and ensure a strong bond between the graphics kit and your jetski.
That’s it! Following these steps should help you to successfully install your graphics kit. If you have any questions or concerns, please don’t hesitate to contact us for further assistance.